0 Items (Empty)
Recently Viewed Items
Your Shopping Cart
Your shopping cart is currently empty. If you would like to make a purchase today, add items to your shopping cart.
This is an outdoor solution 4W bi-directional Booster designed for 2.4GHz wireless LANs. This unit comes with an easy plug-and-play installation, which works together with an indoor Wireless Access Point to improve its operation range and performance.
The unit is ideal for use with 2.4 GHz frequency hopping or direct sequence spread spectrum radio modems and 802.11b/g devices.
The amplifiers increase range by providing transmit gain as well as low-noise receive gain. This receive gain increases the receive sensitivity of wireless LAN Access Point. Full output power of 1W is achieved with only 5 mW input into the Booster.
Cast Aluminum Construction
Power and transmit LEDs
18 dB receive signal gain
High Gain, High Value, High Performance
Increase range of low powered radio modems
|Operation Range||2400-2500 MHz|
|Operating Mode||Bi-directional, half-duplex, Auto-Switching via carrier sensing|
|Transmit Gain||24dB Max. Auto Gain Control|
|Output Power||4W/33dBm nominal for 802.11g/54Mbps|
|Frequency Response||*+- 1dB over operation range|
|Transmit Input Power||Max. 100mW, Min 6mW|
|Receiver Gain||15dB typical|
|Receive Noise Figure||3.5dB typical|
|Connector||N-type female (50 ohm)|
|Power||Direct DC ground at antenna connector|
|Distance*||Up to 2500M (8250ft) depends on environment|
|Dimension (cm)||Amplifier: 11.5cm(L) x 6.5cm(W) x 4.8cm(H)
DC Injector: 7.8cm(L) x 5.6cm(W) x 2.9cm(H)
|Material||Die Casting Aluminum|
DC Injector (48V)
SMA Male RP to N male RG316 cablex1